Touchscreen Controls for a Connected Computer (MFD models)

NOTICE

To prevent corrosion due to moisture, you must use Garmin® GPSMAP® accessory cables when connecting the chartplotter to the computer. Using different cables voids your warranty.

You can connect the chartplotter to a computer to see the computer screen on the chartplotter touchscreen and control the computer using the chartplotter touchscreen. To see the computer screen, you must connect the computer to the HDMI IN port. To control the computer, you must connect the computer to the USB port.

The Garmin HDMI® accessory cable (010-12390-20) is 4.5 m (15 ft) long. If you need a longer cable, you should use an active HDMI cable only. You need an HDMI coupler to connect the two HDMI cables.

For an 8000 series chartplotter, the recommended USB cable (010-12390-10) has a micro-USB end that connects to the chartplotter USB ports. For a 9000 series chartplotter, the recommended cable (010-12390-14) has a USB C end that connects to the chartplotter USB ports. Both of these cables are 4.5 m (15 ft) long. If you need a longer cable, you should use a USB hub or USB repeater extension cable only.
NOTICE

To avoid potential communication errors, you should use the correct USB cable for your chartplotter. You should not use an adapter to change the USB connector type on either of these cables.

You must make all cable connections in a dry environment.


Block diagram

Devices

Item

Device

Callout number 1

Computer

Callout number 2

GPSMAP chartplotter

Connections

From

To

Cable

Callout number 1

Computer's HDMI OUT port

Callout number 2

Chartplotter's HDMI IN port

Garmin HDMI Cable (010-12390-20)

Callout number 3

Chartplotter's USBport

Callout number 4

Computer's USB port

8000 Series Chartplotters: Garmin USB Cable (010-12390-10)

9000 Series Chartplotters: Garmin USB-C to USB-A Cable (010-12390-14)

GUID-25CCEC48-337E-47C0-8B89-5C35CCDB65AC v29
September 2024