Skip to main content

Installing the Handle on the Pull Cable

  1. Insert the pull cable Callout number one through the bottom half of the handle Callout number two.

    Exploded view of handle with callouts
  2. Insert the pull cable through the washer Callout number three.
  3. Push the R-pin Callout number four through the hole on the end of the pull cable.
  4. Pull the cable down so that the washer and R-pin rest in the bottom half of the handle.
    NOTE: The R-pin fits in the bottom half of the handle one way only.
  5. Using a #1 Philips screwdriver, secure the top of the handle Callout number five to the bottom using the screws Callout number six.
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2