Skip to main content

Removing the Pull Cable

Before you can remove the pull cable, you must remove the pull cable handle (Removing the Pull Cable Handle).

  1. Transition the motor to the stowed position.
    CAUTION

    You should leave the motor in the stowed position until you have connected the new pull cable. If the mount is not securely locked in the deployed position, it may shift and crush your hands or fingers.

  2. Locate the access hole on the underside of the mount base.
  3. Using needle-nose pliers, remove the R-pin that secures the pull cable to the locking mechanism.

    R-pin location
  4. Remove the pull cable from the mount base, and pull it through the steering servo housing.
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2