Skip to main content

Removing the Coil Cable from the Steering Servo Housing

Before you can remove the coil cable, you must disconnect the power cable from the steering servo housing (Removing the Power Cable from the Steering Servo Housing).

  1. Using a 4 mm hex bit or screwdriver, remove the three screws that secure the coil cable block to the steering servo housing.

    Disconnecting coil cable
  2. Pull the coil cable block away from the steering servo housing to remove it.
    CAUTION

    The coil cable block connects to the PCB in the steering servo housing. When removing the block take care to avoid damaging the connector on the PCB.

Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2