Skip to main content

Reconnecting the Coil Cable

  1. If you are replacing the coil cable, remove the coil cable from the shaft cap (Removing the Coil Cable from the Shaft Cap).
  2. If necessary, install the replacement coil cable in the shaft cap (Installing the Coil Cable in the Shaft Cap).
  3. Place the coil cable block over the connector on the steering servo housing, and push it into place, taking care to avoid damaging the connector.

    Disconnecting coil cable
  4. Using a 4 mm hex bit or screwdriver, insert and tighten the three screws to secure the coil cable block to the steering servo housing.
  5. tighten the three screws to 20 kgf-cm (17.4 lbf-in)
  6. Reconnect the power cable (Reconnecting the Power Cable).
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2