Skip to main content

Replacing the Locking Mechanism in the Lower Link

Before you can replace the locking mechanism in the lower link, you must remove the lower link from the mount base (Removing the Lower Link from the Mount Base).

  1. If it is still connected, remove the pull cable from the latching mechanism (Removing the Pull Cable).
  2. Using a pair of needle-nose pliers, remove the pins that secure the latch bars to the central rod.

    Removing and installing the latch mechanism pin
    CAUTION

    Take note of the orientation of the latch pins prior to removing them. Installing the latch pins incorrectly may cause damage.

  3. Slide the central rod out of either end of the lower link.

    Removing the latch mechanism
  4. Slide the two latch bars out of the lower link.
    CAUTION

    Take note of the orientation of the latch bars prior to removing them. Installing the latch bars incorrectly may cause damage.

  5. Apply a silicon-based lubricating grease to the replacement latch bars.
  6. Insert the replacement latch bars into the lower link, with the rounded ends of the latch bars facing the hinge end of the lower link.
  7. Insert the replacement rod into either end of the lower link, feeding it through the holes in the two latch bars.
  8. Reinstall the pins to secure the latch bars to the central rod.
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2