Skip to main content

Removing the Lower Link from the Mount Base

Before you can remove the lower link from the mount base, you must remove the steering servo from the mount (Removing the Steering Servo from the Mount).

  1. Rotate the lower link up so you can access the latching mechanism spring.

    Disconnecting and reconnecting latch spring
  2. Using needle-nose pliers, disconnect the spring from the hook on the base of the gas spring.
  3. Using a #2 Phillips screwdriver, remove the pin covers from the sides of the mount base.

    Removing lower link pivot pin from the mount base
  4. Push the pin out from one side and pull to remove it from the mount base.
  5. Lift up to remove the lower link from the mount base.
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2