Installing the Steering Servo on the Lower Link of the Mount
-
Pivot the lower link of the mount forward until it locks into the base.
-
Push the two safety rods
into the lower link as far as possible.
-
From the inside out, insert the bushings
into the lower holes 
on the steering servo housing.
-
Holding the pull cable
up, place the steering servo housing onto the lower link of the mount, aligning the lower holes on the housing with the holes on the link.
-
While lifting up on the steering servo housing, push the pivot pin
through the housing and the link to hold it in place.
Do not hit the pin with a hammer or other object. Do not drill or modify the holes. Although it is a snug fit, the pin slides in completely when pushed by hand. Damage caused by hammering the pin or modifying the holes is not covered under warranty.
-
Route the pull cable upward through the top of the steering servo housing
.
