Installing the Drive Motor and Shaft
You should perform these actions to reassemble the trolling motor after replacing the shaft or transducer.
- Install the shaft in the steering servo housing (Installing the Shaft in the Steering Servo Housing).
- Install the shaft cap on the shaft (Installing the Shaft Cap).
- Install the transducer cable in the shaft cap (Installing the Transducer Cable in the Shaft Cap).
- Connect the cables in the shaft cap (Connecting the Cables in the Shaft Cap).
- Close the shaft cap (Closing the Shaft Cap).
- Route the power and transducer cables through the mount (Routing the Power and Transducer Cables Through the Mount).
- Connect the motor to the power source.