Disconnecting the Upper Link of the Mount
Before you can disconnect the upper link of the mount, you must remove the power and transducer cables from the mount (Removing the Power and Transducer Cables From the Mount).
-
With the motor in the deployed position, disconnect the cable
from the display panel on the upper link of the mount 
.
-
Using an 4 mm hex bit or wrench, remove a screw and washer
from one side of the upper pin 
on the steering servo housing.
TIP: It is helpful to use another 4 mm hex wrench to hold one end of the upper pin stationary while you remove one screw. -
Pivot the upper link away from the steering servo housing.
-
Remove the bushings from the upper holes in the steering servo housing.
