Skip to main content

Replacing the Display Panel

Before you can remove the display panel from the upper link of the mount, you must disconnect the upper link of the mount from the steering servo housing (Disconnecting the Upper Link of the Mount ).

  1. Using a #0 Phillips screwdriver, remove the position sensor Callout number one from the upper link of the mount.

    Removing mount position sensor
  2. Open the cable clips Callout number two to remove the position-sensor cable.
  3. Pinch the tabs on the side of the display panel, and push it out of the upper link from the back.

    Removing display panel
  4. Feed the cable from the replacement display panel through the upper link, taking care to feed the cable completely through the upper link.
    NOTICE

    Use caution when installing the replacement display panel, because the cable may become pinched between the display panel and the upper link. This damages the cable and causes unwanted behavior when stowing the motor.

  5. Secure the replacement display panel by placing it in the upper link and pushing until it snaps into place.
  6. Using a #0 Phillips screwdriver, secure the position sensor to the mount.
  7. Route the position sensor cable through the cable clips and snap them closed to secure the cable.
Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2