Skip to main content

Disassembling the Nose Cone

Before you can disassemble the nose cone, you must remove the skeg and nose cone from the propeller drive motor (Removing the Skeg and Nose Cone).

  1. Using a 3 mm hex bit or wrench, remove the six screws that secure the transducer to the nose cone.

    Eploded view of the nose cone and transducer
  2. Remove the transducer and transducer pad from the nose cone.

    If you are not replacing the transducer, you should keep the transducer pad and six screws so you can secure the transducer to the replacement nose cone.

Copyright © Garmin. All rights reserved.GUID-F61CDD86-17CE-4801-B775-07A31282A541 v2