Connecting the Upper Link of the Mount to the Steering Servo Housing
-
Make sure that the data cable
is accessible, and not trapped by any part of the mount.
-
From the outside in, insert the bushings
in the upper holes on the steering servo housing.
-
Pivot the upper link of the mount forward.
-
Push the pin
through the holes on the upper link of the mount and the steering servo housing.
-
Using a 4 mm hex bit or hex wrench, secure the pin using the screws and washers
on both sides.
NOTE: To properly secure the pin, you should use two hex bits or wrenches so the pin does not rotate as you tighten the screws.