Installing AA Batteries

The device operates on two 1.5 V AA batteries (not included). For the best results, you should use lithium batteries, which provide extended battery life and better performance at low temperatures.

NOTICE

Do not use AA batteries with a voltage specification higher than 1.5 V. Higher voltages will cause permanent damage to the camera. Do not use lithium-ion rechargeable AA battery cells. Lithium-ion batteries use a different technology than non-rechargeable lithium batteries and may permanently damage the camera.

  1. Rotate both battery covers Callout number one toward the front of the camera, and remove the battery covers.

    Device assembly with a callout
  2. Insert a AA battery into each end of the camera, with the positive pole facing outward.

    Device battery installation
  3. On each battery cover, verify the gasket Callout number two is clean and fully seated in the groove.

    Battery gasket with a callout
  4. For each battery cover, place the cover into the camera, press it tightly into the camera, and rotate it toward the back of the camera to lock it into place.
    NOTE: Although the battery covers are interchangeable, it is recommended to install the covers as shown in the illustrations.
    NOTICE

    The camera is not water resistant if the gaskets are not clean and properly seated, and the covers are not properly locked into place.

  5. Verify each cover is fully sealed and no part of either gasket is protruding between the cover and the camera.


Copyright © Garmin. All rights reserved.GUID-A52DB25D-9CB5-49CA-8926-E861641EF176 v3