Skip to main content

Replacing the Coil Cable and Junction Box

  1. Disconnect the power cable and transducer cable (if present).
  2. Remove the mount shrouds (Removing the Mount Shrouds).
  3. Open the shaft cap (Opening the Shaft Cap).
  4. Disconnect the cables in the shaft cap (Disconnecting the Cables in the Shaft Cap).
  5. Remove the coil cable from the shaft cap (Removing the Coil Cable from the Shaft Cap).
  6. Remove the junction box (Removing the Coil Cable Junction Box from the Mount Base).
  7. Connect the new junction box (Connecting the Coil Cable Junction Box to the Mount Base).
  8. Route the new power and transducer cables (Routing the Power and Transducer Cables Through the Mount).
  9. Install the coil cable in the shaft cap (Installing the Coil Cable in the Shaft Cap).
  10. Connect the cables in the shaft cap (Connecting the Cables in the Shaft Cap).
  11. Close the shaft cap (Closing the Shaft Cap).
  12. Install the mount shrouds (Installing the Mount Shrouds).
  13. Reconnect the power cable and transducer cable (if present).
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.