Skip to main content

Disconnecting the Cables in the Shaft Cap

  1. Unscrew and disconnect the GPS data connector Callout number 1.

    Ensure the o-ring remains in place inside the connector.


    Device Top View with Callouts
  2. Release the latch Callout number 2 and pull the connectors apart to disconnect the motor data cable.
    NOTICE

    To avoid damaging the cable, pull only on the connector body. Do not pull on the wire itself.

  3. Unscrew and disconnect the transducer cable Callout number 3 (if present).
  4. Carefully cut off the zip ties Callout number 4.
  5. Slide down the protective coverings Callout number 5 on the power cables.
  6. Using a 2.5 mm allen wrench, loosen the four set screws on the two power cables.
  7. Disconnect the power cables.
  8. Remove the protective coverings from the power cables.
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.