Before you can adjust the behavior or speed of a simulation, you must play the simulation.
-
While the simulation is playing, select
Pause to pause the simulation.
-
While the simulation is paused, select
Play to play the simulation.
-
Select
Loop to set the simulation to stop or repeat when it reaches the end of the route or track.
-
Use the top slider bar to move the simulation forward or backward along the route or track.
NOTE:
shows the current position of the simulation on the map.
-
Use the bottom slider bar to adjust the speed of the animation.
-
Select
Slower to decrease the speed of the animation.
-
Select
Faster to increase the speed of the animation.
-
Select
x Actual Speed, and enter a value to set a specific playback speed.
A value of 1.0 plays the route or track at actual speed.