Skip to main content

Replacing the Full Drive Assembly

  1. Disconnect the power cable and transducer cable (if present).
  2. Remove the mount shrouds (Removing the Mount Shrouds).
  3. Disconnect the junction box (Removing the Coil Cable Junction Box from the Mount Base).
  4. Deploy the motor.
  5. Disconnect the steering servo cables (Disconnecting the Steering Servo Cables).
  6. Remove the servo landing pad (Removing the Servo Landing Pad).
  7. Remove the pivot pin (Removing the Pivot Pin).
  8. While supporting the steering servo, remove the old full drive assembly.
  9. Install servo bushings in the new drive system assembly (Installing the Bushings in the Steering Servo Housing).
  10. Install the new full drive assembly.
  11. Connect the new junction box (Connecting the Coil Cable Junction Box to the Mount Base).
  12. Route the new power and transducer cables (Routing the Power and Transducer Cables Through the Mount).
  13. Install the pivot pin (Reinstalling the Pivot Pin).
  14. Reconnect the steering servo cables (Connecting the Steering Servo Cables).
  15. Reinstall the servo landing pad (Installing the Servo Landing Pad).
  16. Install the mount shrouds (Installing the Mount Shrouds).
  17. Reconnect the power cable and transducer cable (if present).
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.