• Registering Your Vector System
• Introduction
• Pairing Vector with the Garmin Connect App
• Resetting the Vector Pedals
• Pedal-Based Power
• Garmin Connect
• Trademark Notices
• Pairing Vector with Your Edge 1030
• Power Data Fields
• Tools Needed
• Training
• Troubleshooting
• Appendix
• Entering the Crank Length with the Forerunner 935 and fēnix 5 Series
• Upgrading Your Vector 3S to a Dual Sensing System
• Installing the Pedals
• Customizing the Data Fields
• Edge 520 and Edge 820 Instructions
• Device Information
• Preparing for the Installation
• Getting Started
• Forerunner 935 and fēnix 5 Series Instructions
• Edge 1000 Instructions
• Vector Specifications
• Customizing the Settings in the Garmin Connect App
• Vector Device Care
• Maintenance Tips
• Disconnecting the USB Cable
• Vector Storage
• Adjusting the Release Tension
• Battery Information
• Thank You
• Overhauling the Vector Pedals
• Pedal Status LED
• Entering the Crank Length
• Your First Ride
• Other Compatible Devices
• Replacing the Batteries
• Updating the Vector Software Using the Edge 520, 820, 1000, or 1030
• Vector Data
• Pairing Vector with the Edge 1000
• Entering the Crank Length with the Edge 520 and Edge 820
• Sending Your Ride to Garmin Connect
• Pairing Vector with the Edge 520 and Edge 820
• About the Vector 3S System
• Power Phase Data
• Platform Center Offset
• Pairing Vector with Your Forerunner 935 and fēnix 5 Series
• Entering the Crank Length with the Edge 1000
• Using Cycling Dynamics
• Installing the Vector Components
• Cycling Dynamics
• Performing a Static Torque Test
• Installing the Shoe Cleats