Replacing the Batteries

See the Important Safety and Product Information guide in the product box for product warnings and other important information.

Each pedal uses one CR1/3N or 2L76 battery or two LR44 or SR44 batteries.

NOTE: Garmin^® recommends replacing all of the batteries at the same time. Do not mix the battery types.

Use a 4 mm hex key to remove the battery cover .
Remove the batteries.
Wait 5 to 10 seconds.
Insert the new batteries into the battery cover, observing polarity.
Replace the battery cover, and hand tighten it.

NOTE: Do not damage or lose the O-ring gasket.
Use a 4 mm hex key to gently tighten the battery cover.

NOTE: Do not over-tighten the battery cover. The cover is sufficiently tight when the O-ring gasket is no longer visible.

The pedal LED flashes red once.

Vector™ 3 and Vector™ 3S