Skip to main content

Resetting the Vector Pedals

If the device stops responding, you may need to reset it by disconnecting and reconnecting the battery cover. This does not erase any of your data.

  1. Use a 4 mm hex key to remove the battery cover Callout number one.

    Device with the hex key and a glyph
  2. Replace the cover, and hand tighten it.
    NOTE: Do not damage or lose the O-ring gasket.
  3. Use a 4 mm hex key to gently tighten the battery cover.
    NOTE: Do not over-tighten the battery cover. The cover is sufficiently tight when the O-ring gasket is no longer visible.

    The pedal LED flashes red once.

Copyright © Garmin. All rights reserved.GUID-297604DF-2345-43A4-80D2-908E16676B29 v6