Removing the Preinstalled Feet

Removing the Preinstalled Feet

Before removing the preinstalled feet, the assembled speaker and stand must be laying down on the ground at its final location.

Slide top acrylic panel up the post at least 305 mm (12 in.).
Using the included socket tool, remove the panel nut from each corner.
Using the included hex key, turn each foot clockwise until it is removed from each corner.
Select an option:
- To use the speaker on hard floor surfaces, install the short spikes (Installing the Short Spikes ).
- To use the speaker on carpeted floor surfaces, install the long spikes (Installing the Long Spikes ).

GUID-01BDC3A7-6C48-4F80-BE5C-BD0E0D7E0CE7 v2

May 2026

© 2026 Garmin Ltd.

JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page.

Removing the Preinstalled Feet

Before removing the preinstalled feet, the assembled speaker and stand must be laying down on the ground at its final location.

Slide top acrylic panel up the post at least 305 mm (12 in.).
Using the included socket tool, remove the panel nut from each corner.
Using the included hex key, turn each foot clockwise until it is removed from each corner.
Select an option:
- To use the speaker on hard floor surfaces, install the short spikes (Installing the Short Spikes ).
- To use the speaker on carpeted floor surfaces, install the long spikes (Installing the Long Spikes ).