Installing the RV Charging Station Accessory

NOTICE

Failure to heed these installation requirements could result in damage to the product or vehicle.

  • You must choose a suitable mounting location for the charging station before drilling holes in the vehicle wall.

  • You must verify the mounting surface allows the mount to be securely connected and the mounting screws will not interfere with wiring or features in the wall.

  • You must use proper mounting screws for your vehicle's wall material. The included screws are intended for installation on wood or fiberglass walls. Before installing the screws, you must verify the screws are the correct length and will not damage the exterior walls or any other components.

To install the RV charging station accessory, you need a Philips screwdriver and a drill with a 1.5 mm (1/16 in.) drill bit.

The RV charging station accessory provides a permanent, wall-mounted charging station for your device. This allows you to use and charge the device in the living area of your RV.

  1. Place the mount against the wall, and use the six screw holes to mark the pilot-hole locations.
  2. Remove the mount from the surface.
  3. Using a 1.5 mm (1/16 in.) drill bit appropriate for the wall material, drill a pilot hole in each of the six locations you marked.
    NOTICE

    Do not drill through the mount. This could result in damage to the mount or wall.

  4. Line up the screw holes on the wall mount with the pilot holes, and secure the mount to the wall using six screws.

    Mount attached to the wall with screws
  5. Press the socket in the device mount onto the ball of the wall mount until it snaps into place.

    Device mount attachment to the wall mount
  6. Route the bare-wire connectors to the RV battery or a 12 V power source.
  7. Connect the black wire to the negative (-) terminal of the battery, and connect the red wire to the positive (+) terminal of the battery.

    Power cable connection to the RV battery and device mount
  8. Connect the mini-USB end of the power cable to the powered device mount.
  9. Place the navigation device onto the device mount.
Copyright © Garmin. All rights reserved.GUID-260D9C3C-8A96-42DD-8D3B-6F6B7C616338 v5