Attaching the LiveScope Transducer Perspective Mount
You can use this perspective mount to secure any LiveScope™ transducer to the side of your compatible trolling motor shaft or Spy Pole™ mount.
Locate the front half of the perspective
mount , the four black screws , and the 5 mm hex
wrench.
Select the appropriate back mount piece
based on the device to which you are attaching the mount.
NOTE:This kit includes a back piece for both a trolling motor shaft (in bag J) and the Spy Pole™ mount (in bag F).
Identify the arrow on the front half of
the mounting bracket to ensure you install the bracket in the correct orientation when you
secure it to the shaft.
Insert the screws into the back of the
mounting bracket and secure them to the front bracket using the included 5 mm hex wrench.
NOTICE
If you are installing the perspective mount on a Spy Pole™ shaft, the bracket must be aligned so the notch
in the bracket lines up with the grooves in the Spy Pole™
shaft grommet. Misaligning these pieces and tightening the bracket can result in
damage to your Spy Pole™
mount.
