To change the options and settings for the OneVü™ sonar view, select Options.

Contrast

Sets the contrast for the sonar view, which increases the difference between the lightest and darkest areas of the reading.

Brightness

Sets the brightness of the sonar view.

Frequency

Sets the frequency used by the transducer. You can select between Chirp 455 kHz, 810 kHz, and 1070 kHz frequencies based on your needs.

Range

Sets the distance of the range rings on the sonar view.

OneVu™ Scan

Starts and stops OneVü scanning. Select to adjust the scan settings.

OneVu™ Scan > Scan Mode

Sets the method used to control when the scan runs. Select Constant to run the scan continuously. Select Manual to scan only when you choose to initiate a new scan. Select Auto to engage the scan automatically when the vessel enters a new area.

OneVu™ Scan > Speed

Sets the speed of the scan.

OneVu™ Setup

Sets additional OneVü sonar settings (OneVü Sonar Setup).