Installing the LiveScope Transducer Bottom Shaft Mount

Installing the LiveScope Transducer Bottom Shaft Mount

You must install the cable guard grommet on the shaft and route the LiveScope™ transducer cables through the shaft before you can install the bottom shaft mount (Routing Cables Through the Spy Pole).

Slide the LiveScope transducer bottom shaft mount onto the end of the Spy™ pole.
Set the included M6 nut in the enclosure on the bottom shaft mount.
Insert the included M6 50 mm bolt through the bottom shaft mount and tighten it onto the nut using a 10 mm hex wrench or bit.

GUID-CE86F073-380E-435D-8743-D823C364C077 v1

March 2026

© 2026 Garmin Ltd.

JavaScript must be enabled in order to use this site.Please enable JavaScript in your browser and refresh the page.

Installing the LiveScope Transducer Bottom Shaft Mount

You must install the cable guard grommet on the shaft and route the LiveScope™ transducer cables through the shaft before you can install the bottom shaft mount (Routing Cables Through the Spy Pole).

Slide the LiveScope transducer bottom shaft mount onto the end of the Spy™ pole.
Set the included M6 nut in the enclosure on the bottom shaft mount.
Insert the included M6 50 mm bolt through the bottom shaft mount and tighten it onto the nut using a 10 mm hex wrench or bit.