Routing Cables Through the Spy Pole Shaft

You can route cables for a LiveScope™ transducer or other device through the Spy Pole™ shaft to simplify cable management.

  1. Remove any installed attachment from the bottom of the Spy Pole™ shaft.
  2. Route the cable from the transducer or other device up from the bottom of the pole and out through the top.
    NOTE: If you are routing the cable through a tight area and need additional room, you can use the included split connector (Using the Optional Split Collar).
  3. Slide the rubber cable grommet into the slot at the bottom of the shaft, with the larger hole facing down.
  4. At the bottom of the pole, press the cable through the split at the bottom of the grommet and into the hole.

    Cable routing in the bottom of the Spy Pole Mount
  5. Connect or reconnect any bottom attachments to the Spy Pole™ shaft.
  6. Using a #1 Phillips screwdriver, remove the screws and separate the two halves of the shaft cap.
  7. Route the cable from the top of the Spy Pole™ shaft through the hole in the bottom half of the shaft cap.

    Cable routing in the top of the Spy Pole Mount
  8. Starting with the ring side of the cable sleeve, slide it over the cable.
  9. Route the cable and cable sleeve through the exit hole in the top cap.
  10. Using a #1 Philips screwdriver, reinstall the screws to connect both halves of the top cap.
  11. Place the top cap on the Spy Pole™ shaft.
  12. Install the bolt and nut, and using a #2 Phillips screwdriver, tighten the bolt to secure the top cap to the Spy Pole™ shaft.
GUID-CE86F073-380E-435D-8743-D823C364C077 v2
October 2026