Installing Cable Clips

You can use the included cable clips to secure the device cables to the side of the trolling motor.

  1. Decide which side of your trolling motor you want to route your device cables through.
  2. On the same side of the trolling motor, unscrew the existing metal clamp holding the trolling motor power cable if present.
  3. Remove the adhesive liner on the back of one of the cable clip nut plates.
  4. Press the nut plate against the side of the trolling motor where you intend to route the cables.
  5. Remove the adhesive liner on the back of the other cable clip nut plate.
  6. Press the nut plate against the side of the trolling motor on the other end of the cable routing channel.
  7. Route any cables through the brackets of each clip as needed.
  8. Press the top half of each clip into the bracket to secure your cables.
GUID-CE86F073-380E-435D-8743-D823C364C077 v2
October 2026