Connecting a LiveScope Transducer to the Mount

  1. Choose the right adapter disc for your LiveScope™ transducer.
    Each disc is labeled with a different LiveScope transducer model.
  2. Remove the plastic adhesive on the back of the adapter disc and adhere it to the end of the LiveScope transducer bottom shaft mount.
    Make sure you align the pegs on the back of the disc with the holes in the shaft mount.
    Exploded view of installing a LiveScope on the bottom shaft mount
  3. Slide the LiveScope transducer onto the appropriately sized mounting knob.
  4. Screw the mounting knob onto the bottom mount until the LiveScope transducer is loosely attached.
  5. Adjust the angle of the LiveScope transducer as needed, and securely tighten the knob.
    CAUTION
    Do not install more than two transducers on the Spy Pole™ mount. Exceeding this limit may cause premature wear or damage and will void the product warranty.
GUID-CE86F073-380E-435D-8743-D823C364C077 v2
October 2026