Installing the Transducer Using Low Profile Mounting Hardware
If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation without the adjustment knobs, you can use the included hardware to install the transducer instead of using the knobs.
Labels identifying the parts bags required for this procedure:
- Secure the mounting bracket to the trolling motor barrel (Installing the Transducer on a Trolling Motor Barrel) or shaft (Installing the Transducer on the Trolling Motor Shaft ) (Installing the Transducer on the Perspective Mode Mount) according to the appropriate instructions, but do not use the included adjustment knobs.
-
Select an action:
-
If you are installing the transducer on the barrel or shaft of the trolling motor, use the longer low-profile screw and metal washer from parts bag
to secure the transducer to the mounting bracket.
-
If you are installing the transducer using the perspective mode mount and extension arm, use the shorter low-profile screw and metal washer from parts bag
to secure the extension arm to the mounting bracket, and use the longer low-profile screw and metal washer from parts bag to secure the transducer to the extension arm.
-
-
Adjust the view of the transducer and tighten the low-profile screws using the 5 mm hex wrench in parts bag
.