Mounting Considerations
This device should be mounted in a location that is not exposed to extreme temperatures or conditions. The temperature range for this device is listed in the product specifications. Extended exposure to temperatures exceeding the specified temperature range, in storage or operating conditions, may cause device failure. Extreme-temperature-induced damage and related consequences are not covered by the warranty.
When flush-mounting this device in a dashboard or other flat surface, it uses brackets to hold the device in the opening from the back of the surface using tension. When selecting a location, before cutting the opening, you must make sure that you have access to the back of the mounting surface so you can install and secure the brackets on the device. You should also make sure that there is sufficient clearance for the brackets and connected cables behind the mounting surface. The needed clearance varies, depending on the thickness of the mounting surface, the type of brackets used, and the cables you plan to connect.
When flush mounting the device, the curvature of the mounting surface must not exceed 0.5 mm (1/64 in.) Flush-mounting the device on a surface with a curvature that exceeds this allowance may damage the device.
-
The location must allow access to the back of the surface and provide sufficient clearance when mounting the device.
-
When flush-mounting the device, the surface should be relatively flat, with the curvature not exceeding 0.5 mm (1/64 in.).
-
The location should provide optimal viewing as you operate your boat.
-
The location should allow for easy access to all device interfaces, such as the keypad, touchscreen, and card reader, if applicable.
-
The location must be strong enough to support the weight of the device and protect it from excessive vibration or shock.
-
To avoid interference with a magnetic compass, the device should not be installed closer to a compass than the compass-safe distance value listed in the product specifications.
-
The location must allow room for the routing and connection of all cables.
-
When flush mounting the device, the location must not be a flat, horizontal surface. The location should be in a vertical angle.
-
The location and viewing angle should be tested before you install the device. High viewing angles from above and below the display may result in a poor image.