Installing the Transducer Using Low Profile Mounting Hardware
If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation without the adjustment knobs, you can use the included hardware to install the transducer instead of using the knobs.
Labels identifying the parts bags required for this procedure:
- Secure the mounting bracket to the trolling motor barrel (Installing the Transducer on a Trolling Motor Barrel), Spy Pole mount, or trolling motor shaft (Installing the Transducer on the Perspective Mode Mount) according to the appropriate instructions, but do not use the included adjustment knobs.
-
Use the low-profile screw and
metal washer from parts bag to secure the transducer to the mounting bracket.
-
Adjust the view of the
transducer, and tighten the low-profile screws using the 5 mm hex wrench in
parts bag
.