Setting the Fusion PartyBus Device as the DHCP Server
If you connected more than two network devices together using a network switch or wireless access point but you did not install a router, you should configure only one Fusion PartyBus™ stereo to be a DHCP server.
Having more than one DHCP server on the network causes instability and poor performance for all devices on the network.
NOTE:
If you have set up this stereo as a
WI-FI ACCESS POINT, it is configured as a DHCP server by default, and no further settings changes are needed (Setting the
Fusion PartyBus Device as a Wireless Access Point).
-
If the device is connected to the network using an Ethernet cable, select
> SETTINGS > NETWORK > WI-FI OFF.
- If the device is connected to the network using an Ethernet cable, select .
- Select .