Skip to main content

Installing the Saddle


D symbol

Before you install the saddle, see the topics on posture (Cycling Posture) and geometry (Adjusting the Trainer Geometry).

  1. Open the assembly kit Tools symbol.
  2. Use the 6 mm hex key to remove the set screw.

    Set screw and rail
  3. Place the cap Callout number one on the saddle rail Callout number two.

    Saddle assembly with callouts
  4. Slide the saddle Callout number three onto the saddle rail.
  5. Adjust the saddle setback, and secure the M12 x 25 handle Callout number four.

    The maximum setback distance is 15 cm.


    Saddle assembly with callouts
  6. Use the 8 mm hex key to remove the set screw from the saddle post.
  7. Adjust the saddle height, and secure the M16 x 22 handle Callout number five.

    The maximum saddle height is 26 cm.

  8. If necessary, use the 5 mm hex key to adjust the saddle angle bolt Callout number six.
Copyright © Garmin. All rights reserved.GUID-8AA4B804-1987-45AC-8B9D-71AE54BD62B0 v1