Skip to main content

Replacing the Shaft Cap and Antenna Box

Before you replace the shaft cap and antenna box, you must open the shaft cap (Opening the Shaft Cap).

  1. Unscrew and disconnect the GPS data connector Callout number 1.

    Ensure the o-ring remains in place inside the connector.


    Diagram with Callouts
  2. Release the latch Callout number 2 and pull the connectors apart to disconnect the motor data cable.
  3. Liberally apply dielectric grease to both ends of the GPS data connector and the motor data connector.
  4. Connect the GPS data connector to the antenna box on the new shaft cap lid and tighten the collar.
  5. Align both sections of the motor data cable connector, and press together to connect them.
  6. Close the shaft cap lid (Closing the Shaft Cap).
GUID-828BF524-69C7-4E20-A109-CE89908F9BDD v2
June 2024
© 2024 Garmin Ltd.