Creating a Custom Light Mode
You can configure your own flashing pattern by creating a custom light mode.
-
Select an option:
-
To create a solid light mode, select Solid, and use the slider to set the brightness level.
-
To create a flashing light mode, select Add Flash.
-
To set the duration and brightness level of a flash, select the flash from the list, and use the sliders to set each parameter.
NOTE: To create a pause between flashes, you must add a flash and set its brightness to 0%. If you add consecutive flashes with the same brightness level, the light does not turn off in between them. -
To reorder the flash sequence, select
next to a flash, and drag it up or down in the list. -
To test your custom light mode, select Preview.
-
-
Select
to add your custom light mode to the light mode sequence.
NOTE: You can have up to six light modes in the light mode sequence. If necessary, you can select
to remove a light mode from the sequence.