Skip to main content

Reconnecting the Upper Link to the Mount Base

  1. Place the plastic bushings Callout number 1 over the bolts Callout number 2 you removed with the original upper link, or over the two bolts supplied with the replacement upper link.

    Connecting upper link to the mount base with callouts
  2. Place a plastic washer Callout number 3 that you removed with the original upper link or a washer supplied with the replacement upper link between the upper link and the mount base.
    NOTE: Replacement plastic washers may have adhesive on one side. If your washers have adhesive, you can stick them to the mount base to make installing the bolts easier.
  3. Push one of the bolts with a plastic bushing through the upper link and washer, and using an 8 mm hex bit or wrench, screw it into the mount base.
  4. Repeat the previous step on the other side of the mount.
  5. Tighten the bolts to 55 Nm (40.5 lbf-ft.).
GUID-4961C943-E6C7-423B-AC7D-40EC5C713247 v1
March 2025
© 2025 Garmin Ltd.