Getting Started
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Garmin® strongly recommends having an experienced installer with the proper knowledge of electrical systems install the device. Incorrectly wiring the power cable can result in damage to the vehicle, the battery, or the device and can cause bodily injury.
This device must be installed according to these instructions. Failure to install this device in accordance with these instructions could result in serious personal injury, damage to the device and/or vehicle, or poor product performance.
Always choose installation options that do not compromise your vehicle's safety. You assume full responsibility and risk for any vehicle modifications that may impair vehicle functionality.
This device is intended to enhance your situational awareness when used properly. If used improperly, you could become distracted by the connected display, which could lead to an accident causing serious personal injury or death.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling, cutting, or sanding.
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vehicle.
You should always select installation options that do not violate local laws or any applicable lease agreements. It is your responsibility to know and follow all applicable laws in the jurisdictions where the device is intended to be used.
For questions specific to your vehicle, you should contact the vehicle manufacturer. These installation instructions do not apply to a specific vehicle type, and are meant as a guide when installing this product on your vehicle. This list provides an overview of the installation and setup tasks.
- Test the camera locations and plan your installation (Testing the Camera and Transmitter Locations).
- Install the cameras (Mounting the Camera Screw-Down Base Plate).
- Install the transmitter box (Mounting the Transmitter Box).
- Connect the turn signal wires (Connecting the Turn Signal Wires).
- Connect the transmitter box to power (Power Connection).
- Pair the transmitter box with your phone or tablet (Pairing the Camera System with a Phone or Tablet).
- Adjust the cameras (Adjusting the Camera Lens).
- Pair the transmitter box with your compatible Garmin navigator (optional) (Pairing the Camera System with a Garmin Navigator).