Skip to main content

Using the Bilge Pump Switches

You can manually operate connected bilge pumps by using switches 12 and 13 on the Garmin® chartplotter.

  1. From a Garmin chartplotter connected to the same NMEA 2000® network as the Garmin Boat Switch™ device, select Vessel > Switching.
  2. Select an option:

    • Press and hold the bilge pump switch for one second to run the bilge pump for 2 minutes.

    • Press and hold the bilge pump switch for three seconds to run the bilge pump continuously.
      NOTE: Your Garmin chartplotter notifies you every 5 minutes while continuous mode is active.
Copyright © Garmin. All rights reserved.GUID-413FE004-9D7D-474E-8423-3B787BC4A5BF v11