Setting Up the Power-Pole Anchor
Before you can use the chartplotter to control the Power-Pole® anchor, you must select the required installation mode.
The default initial installation mode setting is None. While the installation mode is set to None, the chartplotter control of the Power-Pole anchor(s) is inactive.
-
From the
Power-Pole toolbar, select
> Installation.
-
Select the installation mode that matches the anchor installation on the boat.
-
To control a single port side Power-Pole anchor, select Port .
-
To control a single starboard side Power-Pole anchor, select Starboard.
-
To control dual Power-Pole anchors, select Dual.
-
- Use the slider to set the desired speed for the anchor to deploy and retract.