Positioning Considerations

After you have installed the jack plate mount and connected your transducer, you must adjust the angle and depth.

For the sonar to function properly, the transducer must be fully submerged when operating at speeds up to 19 kph (12 mph). The water line on your boat changes when operating at different speeds so you should test the transducer depth several times.

NOTICE

Your transducer should not be submerged when operating at speeds above 32 km/h (20 mph). Improper installation depth can result in excessive drag forces that damage your transducer, jack plate mount, or your vessel.

The installation angle and depth depends on which viewing mode you select for the transducer.
GUID-1492D076-511B-4A9A-9FF1-C8C50EA630BA v1
October 2026