Performing the Dockside Wizard

  1. Turn on the autopilot.

    The first time you turn on the autopilot, you are prompted to complete a short setup sequence.

  2. If the Dockside Wizard does not start automatically after the setup sequence, on a helm control or the autopilot screen on a chartplotter, select Menu icon > Autopilot Setup > Autopilot Installation Setup > Wizards > Dockside Wizard > Begin.
  3. Select the vessel type.
  4. Set the rudder force to high, medium, or low (Setting the Rudder Force).
  5. Calibrate the rudder sensor (Calibrating the Rudder Sensor).
  6. Test the steering direction (Testing the Steering Direction).
  7. If necessary, select the speed source (Selecting a Speed Source).
  8. Review the results of the Dockside Wizard (Reviewing the Results of the Dockside Wizard).
GUID-0AA4C72D-D42C-4E3C-B2D9-BE6A4A856E49 v1
September 2026