Calibrating the Rudder Sensor
- Position the rudder so that the boat would steer fully starboard, and select OK.
- After the starboard calibration is complete, position the rudder so that the boat would steer fully port, and select OK.
-
After the port calibration is complete, center the rudder position, let go, and select
Begin.
The autopilot takes control of the rudder.
- Without touching the rudder, helm control, or chartplotter, allow the autopilot to calibrate the rudder.
-
Select an option:
-
If the calibration did not complete successfully, repeat the previous steps.
-
If the calibration completed successfully, select Next.
-