Setting the Rudder Force

The rudder-force setting determines the maximum force the actuator can apply when moving the rudder. You should select a force level appropriate for the vessel and steering system. If you are not certain about the rudder force needed for the rudder, it is recommended that you leave the default option of Medium when configuring the autopilot. You can select a different option later, if needed.

NOTICE

You should select the lowest option that provides reliable steering performance to avoid potentially damaging the steering system on the vessel.

NOTE: This setting limits only the maximum force that can be applied by the actuator. This does not affect steering responsiveness or autopilot tuning.
When prompted to select the rudder-force setting, select an option:
High

This option provides maximum force. The actuator provides up to approximately 1,050 pounds of force, and this option should be used only for installations that require the strongest possible force to steer.

Medium

This is the default option and it provides moderate force. The actuator provides up to approximately 600 pounds of force, and this option is suitable for most installations.

Low

This option provides reduced force. The actuator provides up to approximately 400 pounds of force, and this option should be used for installations that require limited force.

GUID-0AA4C72D-D42C-4E3C-B2D9-BE6A4A856E49 v1
September 2026