Installing the Sensors on Your Tires
The Tyre Pressure Monitor System is for use with metal tyre valve stems only. Installation of the Tyre Pressure Sensors on non-metal tyre valve stems may cause tyre and/or tyre valve stem damage which could result in serious personal injury or death.
To prevent possible damage to the sensors or vehicle, ensure each installed sensor does not interfere with the vehicle brakes, suspension components or other installed equipment. If an installed sensor interferes with any installed equipment on the vehicle, do not operate the vehicle with the sensor installed.
To prevent possible tire vibration or uneven tire wear on some vehicles, it may be necessary to balance the vehicle tires after installing the sensor.
Before you install the sensors on your tires, you should set up the sensors with your zūmo® device.