Installing the Seat-Post Mount
-
Use the hex key to remove the screw from the seat-post connector .
-
Place a rubber pad around the seat post, if necessary:
-
If the seat post diameter is from 27 to 28.6 mm, use the thicker pad.
-
If the seat post diameter is from 30.4 to 31 mm, use the thinner pad.
-
If the seat post diameter is from 31 to 31.8 mm, do not use a rubber pad.
-
-
Place the seat-post connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with the grooves on the inside of the seat-post connector.
-
Replace and tighten the screw.
NOTE: Tighten the seat-post clamp until the mount does not slide on the seat post, or to a maximum torque specification of 3 lbf-in. (0.3 N-m). You should check the tightness of the screw periodically.
-
Align the tabs on the back of the device with the seat-post mount notches .
- Press down slightly and turn the device clockwise until it locks into place.
Parent Topic: Tips for Installing the Taillight