Skip to main content

Replacing the Battery

Before you can replace the battery, you must have a small Phillips screwdriver, a small flat screwdriver, and a CR2032 lithium coin-cell battery.

  1. Using a Phillips screwdriver, remove the three screws from the back plate Callout number one.

    Battery case with a callout
  2. Remove the back plate from the remote.
  3. Wrap the end of a small flat screwdriver with tape.

    The tape protects the battery, battery compartment, and contacts from damage.

  4. Carefully pry the battery from the back plate.

    Battery installation
  5. Install the new battery into the back plate with the positive side facing down.
  6. Verify the gasket Callout number two is fully seated in the groove.

    Battery case with callouts
  7. Replace the backplate, aligning the post Callout number three with the gap in the circuit board Callout number four.
  8. Replace and tighten the three screws.
    NOTE: Do not overtighten.
Copyright © Garmin. All rights reserved.GUID-707A217C-08B5-4760-9C4F-6F5B9491AA15 v6