You can customize the dive settings based on your needs. Not all settings are applicable for all dive modes. You can also edit the settings before you start a dive.

Select Dive Setup.

Gases

Sets the gas blends used in the gas dive modes (Setting Up Your Breathing Gases). You can have up to twelve gases for each gas dive mode.

Conservatism

Sets the level of conservatism for decompression calculations. Higher conservatism provides a shorter bottom time and a longer ascent time. The Custom option sets a custom gradient factor.

NOTE: Make sure you understand gradient factors before entering a custom level of conservatism.

Water Type

Sets the water type.

PO2

Sets the partial pressure of oxygen (PO2) thresholds, in bar, for the maximum operating depth (MOD), decompression, warnings, and critical alerts (Setting PO2 Thresholds).

Scuba Alerts

Sets custom alerts for gas dives (Setting a Custom Dive Alert).

Display Settings

Customizes the data screens for each dive mode ( Dive Data Screens). .

Safety Stop

Changes the safety stop duration.

Last Deco Stop

Sets the depth of the final decompression stop.

End Dive Delay

Sets the length of time before the device ends and saves a dive after surfacing.

Dive Shortcuts

Assigns button shortcuts for use during dives ().

Advanced Settings

Customizes advanced dive mode settings (Dive Mode Advanced Settings).