Skip to main content

Installing the Edge Power Mount

You can use the power mount to install your Edge® device and connect it to your eBike. Garmin® recommends that you adjust the mount for the Edge viewing angle before you connect the cable to your eBike.

NOTE: If you do not have this mount, you can skip this task.
  1. Select a secure location to mount the Edge device where it does not interfere with the safe operation of your eBike.
  2. Use the 2.5 mm hex key to remove the screw Callout number 1 from the handlebar connector Callout number 2.

    Mount with callouts
  3. Place a rubber pad around the handlebar:

    • If the handlebar diameter is 25.4 mm, use the thicker pad.

    • If the handlebar diameter is 31.8 mm, use the thinner pad.

    • If the handlebar diameter is 35 mm, do not use a rubber pad.

  4. Place the handlebar connector around the rubber pad.
    NOTE: You should align the contours on the rubber pad with the grooves on the inside of the handlebar connector.
  5. Replace the screw, and use the 2.5 mm hex key to tighten the screw until the mount is secure.
    NOTE: You should check the tightness of the screw periodically.

    Mount with a hex key on handlebars
  6. Open the locking ring Callout number 3.
    NOTE: The locking ring is in the open position when the red line is visible on the side of the mount.

    Mount on handlebars with callouts
  7. Align the tabs on the back of the Edge device with the eBike mount notches Callout number 4.
  8. Press down slightly and close the lever to lock the Edge device into the mount.
  9. Connect the power pod cable Callout number 5 to the compatible power cable on your eBike (Required Cables).

    Mount installed on the bike with a callout
GUID-E67DE53E-5B08-4903-9767-F58973BC1829 v5
December 2024
© 2022 Garmin Ltd.