Sets the method used to turn on the speaker.

The speaker is off and in standby mode.

• This minimizes power consumption but requires more time to turn on.

The speaker turns on automatically when any of the wake sources are activated and turns off when all of the wake sources are removed.

• Wake sources include the 12V remote trigger, analog audio, expansion port, and connectivity from the Primacy^® app.

• When XLR or RCA inputs are selected, the speaker remains on for twenty minutes after the signal is last detected.

• When the rear panel controls are overridden, all wake sources are disabled, except for the Dante^® network interface turn-on command.

The speaker is on and in idle mode.

Sets the turn-on behavior whenever the power switch is set to (automatic).

Eco

The speaker enters sleep mode and requires around 20 seconds to turn on.

Faster

The speaker enters standby mode and requires around 7 seconds to turn on.

Sets the lighting intensity of the top panel LED trim.

Off

The LED trim is off.

Dim

The LED trim illuminates at 50% brightness.

On

The LED trim illuminates at 100% brightness.

This red LED turns on after the speaker has been connected to the Primacy Desktop application or the Primacy Mobile application using the Primacy CS. When connected to a Primacy application, most physical switch and dial controls on the speaker's rear panel deactivate and no longer function. The speaker's settings and controls are transferred to the Primacy CS (Companion Primacy Centerpiece Stereo ).

• The power switch and Eco/Faster switch remain active and continue to function.

• When the rear panel controls are overridden, a change to any of the switch positions causes the red LED to flash three times.

• To reactivate the rear panel controls, you must reset the speaker to its original factory default settings ( Connections Panel Identification).

This multicolor LED reports the speaker's status and operating condition (Status LED).